Custom electronics meet real soil, solar power and the practical work of installation.

Let conditions guide control.

The project set out to control irrigation using soil-moisture and ambient-humidity readings, rather than relying solely on manual decisions.

A board built for the job.

A custom PCB uses an ESP32-S3-WROOM, relay switching, sensor connections and visible status indicators. A purpose-designed enclosure brings the electronics into a deployable assembly.

The field is part of the design.

The original account describes solar pole stations, installation, wiring checks and sensor calibration in the field. Multiple units were built, but no production-scale claim is made here.

From circuit to system.

The story shows why power infrastructure, housing and installation belong in the engineering brief alongside firmware. The source does not provide independently verified water or energy savings.

FROM THE FOUNDER’S JOURNAL

This editorial is based on Ruhul Ameen’s published project account. Project descriptions and reported outcomes are attributed to that source.

READ THE ORIGINAL ARTICLE (opens in a new tab)